Ge Profile Refrigerator Water Filter Reset

Ge Profile Refrigerator Water Filter Reset

GE® & GE Profile™ Series. After you change the filter the RESET WATER FILTER must be pressed and held until the red light goes off.. If the unit is a bottom-mount refrigerator and uses the RPWFE water filter, it uses radio. The ID chip on the filter detects when a wrong or non-genuine GE Appliance part is used.
Bottom Freezer Refrigerator – No Filter Reset Pad. On bottom freezer refrigerators that use the RPWFE water filter, the unit uses radio frequency identification .
Run water from the dispenser for 3 minutes (about 1 ½ gallons) to clear the system and prevent sputtering. Reset the indicator light (on models with this feature): Press and hold the RESET WATER FILTER pad on the dispenser for 3 seconds until the light goes off or turns green.
The water filter warning light or message is reset by pressing the Ice & Water pad on the control panel for three seconds. The filter light should turn green, and the filter status will show Good.
Reset Refrigerator Water Filter Indicator Light Reset Filter Indicator Light How to Reset Refrigerator Water Filter Indicator Light. Amana/Sears(596.series) – press and hold the dispenser lock and auto light buttons (at the same time) for 4 seconds until the filter status indicator begins to flash, then release.
This refrigerator uses the OEM GE RPWFE water filter with an RFID chip, which the refrigerator uses to track whether the water filter has been .

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.