How To Install Refrigerator Water Line

How To Install Refrigerator Water Line

refrigerator water line to the stop valve with a compression joint. Then attach the tubing to the back of the cabinets every 2 to 4 ft. using 1/4-in. nylon wire/cable clamps. Once you're outside the last cabinet, don't attach any clamps; just run the tubing to the floor near the water line hookup on the fridge.
Refrigerators with automatic ice makers are a great convenience, especially on a hot day. However, there is nothing automatic about getting a water line hooked .
A refrigerator water line should last for many years, but if it begins to leak it's time to replace it with a new one. Many home improvement and hardware stores .
This water line is connected to the rear of the refrigerator from a cold-water supply line. Whether you're replacing a broken one or putting a new one in, installing .
Installing a water line to a refrigerator is a complex but doable DIY project, perfect for anyone who is comfortable working with their plumbing.
Cut the cold water line under the sink or in the basement and attach a copper T-fitting. Attach a water valve to the T-fitting. This will control the water flow and water pressure to the refrigerator. Be sure to put a gasket seal between the valve and the T-fitting.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.